NAME

HA_1_1_1 - BE - Unrecognized MH Type value

TARGET

Router

TOPOLOGY

       NUT
        |
--------+-------+------- Link0
                |
               MN0

Link0	global	3ffe:501:ffff:100::/64	home link
MN0	global	3ffe:501:ffff:100:200:ff:fe00:a2a2	home address
	ether	00:00:00:00:a2:a2

INITIALIZATION

• Reboot NUT (reboot.rmt)
• Enable HA function (mip6EnableHA.rmt)
• Configure routing table of NUT (route.rmt)

Check Link0 routing table

  NUT
(Link0)   MN0
   |       |
   | <---- | Echo Request
   | ----> | Echo Reply
   |       |

1. MN0 sends Echo Request
2. MN0 receives Echo Reply

• Initialize IPsec configuration (ipsecEnable.rmt, ipsecClearAll.rmt)
• Set IPsec configuration (ipsecSetSAD.rmt, ipsecSetSPD.rmt)
  • ESP transport mode (BU/BA)

TEST PROCEDURE

Check home registration

  NUT
(Link0)   MN0
   |       |
   | <---- | BU (type=0xff, A=1, lifetime=0x0010) (SPI=0x101)
   | ----> | BE
   |       |

1. MN0X sends Echo Request w/ BU
    packet format is:
        Binding_Update_message_format_from_MN_to_HA_ESP.gif
2. MN0X receives BE
    packet format is:
        IPv6 header (source = home agent, destination = home address)
        ESP header
        Mobility header
            Binding Error

JUDGEMENT

PASS: MN0 receives BE

REFERENCE

   Mobility Header processing MUST observe the following rules:

   o  The checksum must be verified as per Section 6.1.  Otherwise, the
      node MUST silently discard the message.

   o  The MH Type field MUST have a known value (Section 6.1.1).
      Otherwise, the node MUST discard the message and issue a Binding
      Error message as described in Section 9.3.3, with Status field set
      to 2 (unrecognized MH Type value).

   o  The Payload Proto field MUST be IPPROTO_NONE (59 decimal).
      Otherwise, the node MUST discard the message and SHOULD send ICMP
      Parameter Problem, Code 0, directly to the Source Address of the
      packet as specified in RFC 2463 [14].  Thus no Binding Cache
      information is used in sending the ICMP message.  The Pointer
      field in the ICMP message SHOULD point at the Payload Proto field.

   o  The Header Len field in the Mobility Header MUST NOT be less than
      the length specified for this particular type of message in
      Section 6.1.  Otherwise, the node MUST discard the message and
      SHOULD send ICMP Parameter Problem, Code 0, directly to the Source
      Address of the packet as specified in RFC 2463 [14].  (The Binding
      Cache information is again not used.) The Pointer field in the
      ICMP message SHOULD point at the Header Len field.

   Subsequent checks depend on the particular Mobility Header.