Date: Tue, 13 Sep 2005 13:47:59 -0600 From: "Francisco Castellon" <FCastellon@tadboise.com> Subject: [users:00111] Certification Questions To: <users@tahi.org> Cc: "Jeremy Richards" <JRichards@tadboise.com> Message-Id: <4175B1798DFA5541AA41EBFB4482B013016366@sbserver> X-Mail-Count: 001111) Hello, I had a question I was hoping you might have an answer too. In regardsto performing specific manual tests for phase II, the very first fullrun I performed on my device went well. There were very few failures andI was interested in re-running only those tests that did not pass. Iused the following command [ make AROPT=" -s X -e X" ipv6ready_p2_host =]with great success and got those remaining tests to pass. The question I have is when I perform a rerun on a specific test, Ialways have to do a [make clean ] or remove the "index.html" file. Thisclears all my old results. 1) Is there anyway to rerun a specific test and keep the resultsfor all the remaining tests that passed all within the same section? Isit acceptable when you send your results in for certification to sendthe first full run and then smaller rerun with it? Thank You, 2) When performing a test against a device that is technicallyconsidered a "host", but does not have the ability to perform a "Ping6"such as portions of the certification in Section 4 and 5 in phase II(three tests), what is the correct way to handle such said tests whensending in for certification? Is it ok to edit these tests out in suchmanner or do I leave these in as fails and write and explanation as towhy these cannot be performed on devices such as printers? Thank You,111_2.html (attatchment)(tag is disabled)