Hi,
I didn't get any answer, so I resend an explanation.
As described below, in test 7_1_2 and 7_1_4 TAHI expects
to receive the DHAAD reply with source address sets to
RUT(Link1, global).
However, RFC3775 Section 10.5 says:
"A home agent receiving a
Home Agent Address Discovery Request message that serves this subnet
SHOULD return an ICMP Home Agent Address Discovery Reply message to
the mobile node with the Source Address of the Reply packet set to
one of the global unicast addresses of the home agent."
In addition, in section 6.9.1.2.1 and 6.9.1.2.2 of the specification
(http://www.ipv6ready.org/pdf/mipv6_ha_testspec_phase2_r3_1_5.pdf), the
expected source address of the DHAAD Reply is RUT(Link0, global).
So, maybe these tests are too strict. Any comments ? Should I submit a patch ?
Regards,
Nicolas
Le 16.03.2007 11:32, Nicolas DICHTEL a ñÄrit :
> Hi,
>
> what's the status about this "problem" ?
>
> Nicolas
>
> Le 26.01.2007 16:18, Nicolas DICHTEL a ñÄrit :
>> Hello,
>>
>> I've tested the new release of TAHI HA (ct-mip6-ha-4.0.4).
>> In test 7_1_2, 7_1_4, my HA uses RUT(Link0, global) as source address to
>> send DHAAD reply (as described in the HTML page), but
>> TAHI expects to receive a DHAAD reply with source address
>> set to RUT(Link1, global). So test is FAIL.
>> Is it an error ? If not, why is it mandatory to use RUT(Link1, global)
>> and
>> not RUT(Link0, global) ?
>>
>>
>> Regards,
>> Nicolas
>
>
>
>