Hello,
I am sorry. I did not find your pre-mail.
The home agent should use the source address relevant to home prefix for
the home agents anycast address. Therefore, the address (Link0, global)
must be good. And the address (Link1, global) must be fail.
Now I tested on the 4.0.4 and the newest 4.0.6, but the tester fault was
not found although checked. The HA replyed the HAAD reply with the source
address (Link0, global), and the testers judged PASS.
If you can, please send your test results to me or mipv6_support@v6pc.jp.
Best Regards.
Best regards
---
Kiyoaki KAWAGUCHI
"Nicolas Dichtel <nicolas.dichtel@6wind.com>" wrote:
> Hi,
>
> I didn't get any answer, so I resend an explanation.
> As described below, in test 7_1_2 and 7_1_4 TAHI expects
> to receive the DHAAD reply with source address sets to
> RUT(Link1, global).
> However, RFC3775 Section 10.5 says:
>
> "A home agent receiving a
> Home Agent Address Discovery Request message that serves this subnet
> SHOULD return an ICMP Home Agent Address Discovery Reply message to
> the mobile node with the Source Address of the Reply packet set to
> one of the global unicast addresses of the home agent."
>
> In addition, in section 6.9.1.2.1 and 6.9.1.2.2 of the specification
> (http://www.ipv6ready.org/pdf/mipv6_ha_testspec_phase2_r3_1_5.pdf), the
> expected source address of the DHAAD Reply is RUT(Link0, global).
>
> So, maybe these tests are too strict. Any comments ? Should I submit a patch ?
>
>
> Regards,
> Nicolas
>
> Le 16.03.2007 11:32, Nicolas DICHTEL a ñÄrit :
> > Hi,
> >
> > what's the status about this "problem" ?
> >
> > Nicolas
> >
> > Le 26.01.2007 16:18, Nicolas DICHTEL a ñÄrit :
> >> Hello,
> >>
> >> I've tested the new release of TAHI HA (ct-mip6-ha-4.0.4).
> >> In test 7_1_2, 7_1_4, my HA uses RUT(Link0, global) as source address to
> >> send DHAAD reply (as described in the HTML page), but
> >> TAHI expects to receive a DHAAD reply with source address
> >> set to RUT(Link1, global). So test is FAIL.
> >> Is it an error ? If not, why is it mandatory to use RUT(Link1, global)
> >> and
> >> not RUT(Link0, global) ?
> >>
> >>
> >> Regards,
> >> Nicolas
> >
> >
> >
> >
>
>
>