Attached are the tn.def's and nut.def's required.Config.txt is in here, and the failed results of the REGISTER test.The file Command Logs.txt shows what echoed when the test was run.v6Eval version is: 3.0.15koi version is: 2.1.1Test Package is: ct-sip-ipv6-ua-1.4.4.tar.gzI only changed the first line of config.txt as the documentation says, =my SIP software has an assigned address, so this is set to my tested =machine's IP. Nothing else in config.txt has been touched.David Rodrigue, Software Developert: 613.739.5976 ext.258e: davidr@macadamian.comMacadamianThe Product Creation PartnerUser Research, Usability, Software Development, Technical Writing and =QA.www.macadamian.com Ottawa. Toronto. San Jose. Boston. Cluj . Yerevan . Nagpur.CONFIDENTIALITY: The information contained in this email is intended by Macadamian =Technologies Inc. for the use by the named individual or entity to which =it is addressed and may contain information that is privileged or =confidential. It is not intended for transmission to, or receipt by, any =individual or entity other than the named addressee expressly permitted =in this email. If you have received this email in error, please delete =it without copying or forwarding it, and notify the sender.-----Original Message-----From: Yoshihiro Inoue [mailto:yoshihiro.inoue@ntt-at.co.jp] Sent: Tuesday, October 14, 2008 3:45 AMTo: davidr@macadamian.comCc: users@tahi.orgSubject: Re: [users:00918] Assistance with getting TAHI and SIP =testing...Hi David,Please check followings, 1. Do you set up v6eval/etc/tn.def and nut.def? 2. Do you set up koi/etc/tn.def and nut.def? 3. You must not change config.txt except your address. (It seem using 2001::, you must use default config.txt) 4. Did you start "koid" before start tests?If you want more support, please send us followings, 1.config.txt 2.command logs 3.v6eval/tn.def and nut.def 4.koi/tn.def and nut.def 5.test tool version and koi version. 6.test logs (*.html and *.dump)Regards,YoshihiroDavid Rodrigue =$BeaJe#sea(I/$Bk{(I8$Bea:e"@eaNe"!(B:=> Hello everyone.> > > > I$Bc`QW(Be just recently installed the TAHI test suite, along with =Koi and the > SIP conformance tests.> > > > Now, I think I$Bc`QW(Be configured everything correctly, but I =can$Bc`QU(B seem to > get the test to accept any of my SIP messages.> > I$Bc`QN(B testing with just the first test, the REGISTER test, but =even though > the tool picks up the message, it doesn$Bc`QU(B seem to want to =process it, > and I can$Bc`QU(B figure out why.> > Attached are the reports of the fail.> > > > My problem I think is that the software I must test does not > differentiate the different proxies.> > So the outbound proxy, the registrar, and my URI$Bc`QT(B all contain =the same > address. > > > > Is this a problem when using the test suite? I$Bc`QW(Be tried to =modify > config.txt to all point to the same address ie: under.test.com but =when > I do that, the REGISTER messages don$Bc`QU(B make it through at all.> 922_2.gz